cobra mikroStar — Satellite Communication and Remote Control System for Drones and UGVs
Control, video and telemetry over a satellite channel or radio. A single application in Ukrainian and a direct link to the aircraft — in one system.
- Two channels of different nature — satellite and a dedicated radio link
- P2PConnect — a direct link to the aircraft over Starlink
- A single CobraQGC application in Ukrainian
- Quick installation, no soldering — 8 steps
- Any ArduPilot platform
Channel architecture
Key advantages
No line of sight needed
The satellite channel works where radio cannot reach — behind terrain, buildings or obstacles, where direct radio visibility is impossible.
End-to-end encryption
Control and video travel through a protected tunnel, with end-to-end encryption in direct-link mode.
Redundant RC channel
RC control is duplicated over Herelink, while the second channel runs by satellite or wire. One route drops — control remains.
Tens of milliseconds
Over a direct P2P link the latency is within tens of milliseconds, as with traditional radio links.
Auto-recovery
After a dropout, a reboot or a network change the channel comes back up by itself — with no manual operator input.
Deploy anywhere
The station is not tied to a location or a provider — it works anywhere there is Starlink or a wired link, even behind CGNAT.
Technical specifications
What’s in the kit
Base configuration
- Network module in a dedicated enclosure
- Cable set
- CobraQGC software
- Access to the fleet management panel on the server
Optional
- RadioMaster TX16S, TX12S or Boxer controller
- COBRA antenna system for extended radio range
When there are dozens of aircraft
Device inventory
A web panel shows which stations and aircraft are assigned to the unit and what state they are in.
Self-service
Replacing a station or an aircraft is done by the unit itself, without contacting the manufacturer. Permitted for the operator-pilot.
Access separation
Each unit sees only its own devices and its own operators.
Frequently Asked Questions
How many steps does onboard installation take?
Eight. All connections are made with connectors, no soldering required. Flight controller parameters are not changed, and the order of cable connection does not matter.
Does the flight controller need configuring?
No. Configuration is handled on the module side; no changes to ArduPilot settings are required.
What language is the control software in?
CobraQGC is localised in Ukrainian, with around 98.5% interface coverage. Flight, controller setup and link diagnostics are in a single window, so operators do not need retraining on an English-language interface.
Can a COBRA remote antenna be connected?
Yes. COBRA antennas connect to the controller; for maximum radio range the COBRA XL-E antenna system is used. See COBRA remote antennas.
Are there platform speed limits?
Around 60 km/h — this is a limitation of the satellite terminal, not of the system. Not critical for a heavy multirotor; for faster platforms it requires verification.
Send an enquiry
Get in touch — we’ll answer questions about the kit, compatibility with your platform and lead times.